ECO-Turbo Start-Up and Extended Warranty Registration

Step 1 of 4

25%

Distributor Information

Distributor Name(Required)

Distributor Phone Number(Required)

Distributor Email(Required)

Distributor Technician(Required)

First Last

Customer (End User) Information

Company (End User) Name(Required)

Company (End User) Address(Required)

Street Address Address Line 2 City State / Province / Region ZIP / Postal Code Country

Company (End User) Phone Number(Required)

Company (End User) Email(Required)

Company (End User) Contact(Required)

First Last

Industry Type(Required)

Industry Description (if necessary)

Compressor Information

Compressor Model(Required)

Compressor Serial Number(Required)

Was this compressor started up by an authorized FS-Curtis Distributor?(Required)

Yes

Date of Start-up(Required)

Month

Day

Year

Hours of Operation

Describe Typical Hours of Operation(Required)

Days per Week(Required)

Hours per Day(Required)

Requirements

The following checklist does not replace the instructions contained in the FS-Curtis Operator’s Manual. Always refer to the Operator’s Manual for proper procedures, methods, operating specifics, and safety precautions. Check below that each requirement has been met per the unit specific FS-Curtis Operator’s Manual.

Requirement Checklist(Required)

Installation Requirements

Pre-Start Requirements

Safety Requirements

Electrical Connection Requirements

Start-Up Requirements

Channel Partner / End User Review

Operational Requirements

Total Hours(Required)

Load Hours(Required)

Live Voltage (Static)(Required)

L1 / L2

L2 / L3

L1 / L3

Live Voltage (Max PSI)(Required)

L1 / L2

L2 / L3

L1 / L3

Full Load Amps (Max PSI)(Required)

Unload Amps(Required)

Control Voltage(Required)

PSI Settings Load(Required)

PSI Settings Unload(Required)

Separator DP(Required)

Lubricant Used(Required)

System Air Receiver Size(Required)

Lubricant Gallons(Required)

ECO-Turbo Warranty / Start-up Registration Notes

Verify alignment has been completed.(Required)

Yes

Auxiliary control supply air pressure (75 - 125 psi).(Required)

Adjust pressure regulator valve if needed. (>4.5 psi). Record Regulator Pressure.(Required)

Adjust pressure relief valve if needed (Set relief pressure to 6 psi). Record Relief Pressure.(Required)

Adjust Seal pressure regulator valve if needed (5 psi). Record Seal Pressure.(Required)

Adjust the oil pressure regulator valve if needed (25-30 psi). Record Set Pressure.(Required)

Confirm that the HMI Oil Pressure transducer display value is between 25 - 30 psi -> start the oil pump in normal mode.(Required)

Yes

Check the water pressure (45 - 75 psi). (Only if water-cooled.)

Yes

Verify the water Temperature (<86°F). (Only if water-cooled.)

Yes

Verify valve actuator air source is active prior to starting (75 - 125 psi).(Required)

Yes

Verify the valve positioner control air source prior to starting (30 - 60 psi).(Required)

Yes

Remove the motor cover and Coupling -> Perform a momentary test to check the Main motor direction and fan direction (Facing the machine spindle, clockwise rotation (CW) for the air-cooled fan; counterclockwise rotation (CCW) from bottom.(Required)

Yes

Verify you are human

Support

ECO-Turbo Start-Up & Extended Warranty Registration

Distributor Information

Customer (End User) Information

Compressor Information

Hours of Operation

Requirements

Operational Requirements

ECO-Turbo Warranty / Start-up Registration Notes